 -     A   SKEPTICs   GUIDE
 -     A   SKEPTICs   GUIDE    
 
 
 
 
   
We have argued on an abstract basis that the state 
of highest entropy (and hence the most probable state) 
for any complicated system is the one whose macroscopic 
properties can be obtained in the largest possible number 
of different ways; if the model systems we have considered 
are any indication, a good rule of thumb for how to do this 
is to let each ``degree of freedom'' of the system contain 
(on average) an equal fraction of the total energy  U.  
We can justify this argument by treating that degree of freedom 
as a ``system'' in its own right (almost anything can be a ``system'') 
and applying Boltzmann's logic to show that the probability 
of that microsystem having an energy 
 while in thermal equilibrium at temperature
while in thermal equilibrium at temperature  decays exponentially as
decays exponentially as 
 .
This implies a mean
.
This implies a mean 
 on the order of
on the order of  ,
if we don't quibble over factors comparable to 1.
,
if we don't quibble over factors comparable to 1.  
The Equipartition Theorem, which is more rigourously valid than the above hand-waving would suggest,15.25 specifies the factor to be exactly 1/2:
A system in thermal equilibrium with a heat reservoir at temperaturewill have a mean energy of
per degree of freedom.
In an ideal monatomic gas of  N  atoms at temperature   each atom has three degrees of freedom: 
left-right (x), back-forth (y) and up-down (z).  
Thus the average internal energy of our monatomic ideal gas is
 each atom has three degrees of freedom: 
left-right (x), back-forth (y) and up-down (z).  
Thus the average internal energy of our monatomic ideal gas is 
It also means that if we change the temperature 
of a container of gas, the rate of change 
of the internal energy  U  with temperature, 
which is the definition of the  HEAT CAPACITY 
|  | (15.19) | 
 and
 and  
 ,
,
 
 and so the heat capacity of an ideal gas is constant:
 and so the heat capacity of an ideal gas is constant:  
| ![\begin{displaymath}C \hbox{\rm ~[ideal gas]} \; = \; {3 \over 2} \, N \, \kB
\end{displaymath}](img144.gif) | (15.20) | 
Now let's examine our gas from a more microscopic, 
``mechanical'' point of view:  
picture one atom bouncing around inside 
a cubical container which is a length  L  on a side.  
In the ``ideal'' approximation, 
atoms never hit each other, but only bounce off the walls, 
so our consideration of a single atom should be 
independent of whether or not there are other atoms 
in there with it.  Suppose the atom in question has 
a velocity   with components  vx, vy and vz 
along the three axes of the cube.
 with components  vx, vy and vz 
along the three axes of the cube.  
Thinking only of the wall at the  +x  end of the box, 
our atom will bounce off this wall at a rate  1/t 
 where  t  is the time taken to travel a distance 
 2L  (to the far wall and back again) 
at a speed  vx:  
t = 2L/vx.  
We assume perfectly elastic collisions 
-- i.e. the magnitude of  vx  does not change when 
the particle bounces, it just changes sign.  
 Each time our atom bounces off the wall in question, 
it imparts an impulse of  2 m vx  to that wall.  
The average impulse per unit time (force) 
exerted on said wall by said atom is thus 
 
F1 = 2 m vx/t  or  
F1 = m vx2/L.  
 This force is (on average) spread out 
all over the wall, an area  A = L2, 
 so that the force per unit area (or pressure) 
due to that one particle is given by 
 
p1 = F1/A = m vx2/L3.  
 Since  L3 = V,  the volume of the container, we can write 
 
p1 = m vx2/V  or 
 
 ,
 where the ``
,
 where the ``
 '' notation means the average of 
the quantity within the angle brackets.  Thus
'' notation means the average of 
the quantity within the angle brackets.  Thus 
Now, the kinetic energy of our original atom is explicitly given by 
 
 is the vector velocity.  
We expect each of the mean square velocity components
 is the vector velocity.  
We expect each of the mean square velocity components 
 
 ,
,
 
 and
 and  
 to average about the same 
in a random gas, so each one has an average value of
 to average about the same 
in a random gas, so each one has an average value of 
 
 of their sum.15.28
Thus
 of their sum.15.28
Thus 
 
 and the mean kinetic energy 
of a single particle is
 and the mean kinetic energy 
of a single particle is 
 
 .
 The kinetic energy of all  N  atoms is just  U = N U1,  or
.
 The kinetic energy of all  N  atoms is just  U = N U1,  or 
 ;
 so we may write15.29
;
 so we may write15.29
Combining Eqs. (21) and (23), we obtain 
the famous  IDEAL GAS LAW:  
|  | (15.24) | 
Despite the flimsiness of the foregoing arguments, 
the  IDEAL GAS LAW is a quantum mechanically correct description 
of the interrelationship between the pressure  p, 
 the volume  V  and the temperature  
 of an ideal gas of  N  particles, as long as the only way 
to store energy in the gas is in the form of the kinetic energy 
of individual particles (usually atoms or molecules).  
Real gases can also store some energy in the form of 
rotation or vibration of larger molecules made of several atoms 
or in the form of potential energies of interaction 
(attraction or repulsion) between the particles themselves.  
It is the latter interaction that causes gases to spontaneously 
condense, below a certain boiling point  Tb, 
 into liquids and, at a still lower temperature 
 Tm  (called the melting point), into solids.  
However, in the gaseous phase even carbon [vaporized diamond] 
will behave very much like an ideal gas at sufficiently high 
temperature and low pressure.  It is a pretty good Law!
 of an ideal gas of  N  particles, as long as the only way 
to store energy in the gas is in the form of the kinetic energy 
of individual particles (usually atoms or molecules).  
Real gases can also store some energy in the form of 
rotation or vibration of larger molecules made of several atoms 
or in the form of potential energies of interaction 
(attraction or repulsion) between the particles themselves.  
It is the latter interaction that causes gases to spontaneously 
condense, below a certain boiling point  Tb, 
 into liquids and, at a still lower temperature 
 Tm  (called the melting point), into solids.  
However, in the gaseous phase even carbon [vaporized diamond] 
will behave very much like an ideal gas at sufficiently high 
temperature and low pressure.  It is a pretty good Law!  
 
 
 
 
